Exploranium KT-9 User Manual page 32

24
N -P mode
O IN
Taking measurements
Summary
Taking a reading in the P
three step procedure:
1 Press the P against the sample.
IN
2 Remove the KT-9 after the beep (it is measuring the zero).
3 The result is displayed after the second beep.
The N mode (sometimes referred to as the zero-read-zero
-P
O IN
method) requires that the measuring pin be replaced by the
in order to allow the sensor to come in direct contact with
S
TUD
the samples. The S
of the storage case (as shown in Figure 12 on page 42) can be
seen in the following figure.
Figure 7 Pin and stud components for sensor
Installing the S
1 Unscrew the P
age compartment of the carrying case.
2 Screw the S
TUD
sensor. You may need a small screwdriver for this
operation.
mode (read-zero method) is a simple
IN
should be located in the lid compartment
TUD
TUD
from the sensor and place it in the lid stor-
IN
snugly into the hole on the front of the