Table of Contents
Advertisement
From a cable length of 300m or to 32 connected DMX devices, the signal should be amplified by a DMX splitter /
repeater (eg Involight DMXS4, DMXS6 or DMXS8) to ensure error-free data transmission.
IMPORTANT: The last device in a DMX chain should have a terminator connected to terminate the chain. DMX
terminators are commercially available, but can also be built yourself. A 120 ohm resistor must be soldered in an
XLR plug between the two poles (+ and -).
DMX connectors:
4.5 MASTER-SLAVE mode:
When you configure a group of devices in the "Master / Slave" mode, the first device controls the others and allows
an automatic or music-controlled and synchronized show. This feature is especially useful for starting a show with-
out great programming. Connect the DMX output of the master device to the DMX input of the first slave device.
Then, connect the DMX output of the first slave device to the DMX input of the second slave device, and so on.
4.6 STAND-ALONE mode:
A TRINITY150LED can also be used in stand-alone mode without a DMX controller. Disconnect Trinity150LED
from the controller and call the pre programmed program.
5. Part DMX-Assignment.
A TRINITY150LED has 15 és 20 channel modes.
NOTE: Basic knowledge of the DMX512 control standard is required so that the device can be operated and
programmed correctly with a DMX controller
Mode/Channel
DMX
DMX
Mode
Mode
20CH
15CH
1
1
2
FunKCIÓ
ÉRTÉK
PAN
0-255
PAN Fine
0-255
LEÍRÁS
PAN movement
PAN FINE movement
13
Advertisement
Table of Contents
