Toyotomi CTN-228W User Manual page 22

the remote controller.
Hold «WiFi» button for 5s to turn off WiFi function and «WiFi» icon will
disappear.
Under off status, press «MODE» and «WiFi» buttons simultaneously for 1s,
WiFi module will restore factory settings.
Function introduction for combination buttons
Energy-Saving Function
Under cooling mode, press «TEMP/HUM.» and «TIMER» buttons
simultaneously to start up or turn off energy-saving function. When energy-
saving function is started up, «SE» will be shown on remote controller, and
air conditioner will adjust the set temperature automatically according to ex-
factory setting to reach to the best energy-saving effect.
Press «TEMP/HUM.» and «TIMER» buttons simultaneously again to exit
energy-saving function.
NOTE
• Under energy-saving function, fan speed is defaulted at auto speed and it
can't be adjusted.
• Under energy-saving function, set temperature can't be adjusted.
• Sleep function and energy-saving function can't operate at the same time.
If energy-saving function has been set under cool mode, press «SLEEP»
button will cancel energy-saving function. If sleep function has been set
under cool mode, start up the energy-saving function will cancel sleep
function.
Child Lock Function
Press «+» and «-» simultaneously to turn on or turn off child lock function.
When child lock function is on, «
you operate the remote controller, the «
sending signal to the unit. To turn off this function, press the + and - buttons
again at the same time.
Temperature Display Switchover Function
Under OFF status, press « - « and «MODE» button simultaneously to switch
temperature display between °C and °F.
» icon is displayed on remote controller. If
»icon will blink three times without
22
GB