Toyotomi CTN-228W User Manual page 18

NOTE
• Press this button continuously more than 2s, the main unit will swing back
and forth from left to right, and then loosen the button, the unit will stop
swinging and present position of guide louver will be kept immediately.
• Under swing left and right mode, when the status is switched from off to
, if press this button again 2s later,
directly; if press this button again within 2s, the change of swing status will
also depend on the circulation sequence stated above.
10 button
Press this button under cooling mode can select 25℃(77℉) fast cooling mode,
16℃(61℉) fast cooling mode and normal cooling mode circularly.
« » icon will be displayed on the remote controller under fast cooling mode.
Once it enters into fast cooling mode, the fan speed is auto fan and the set
temperature is 25℃(77℉) or 16℃(61℉). At this time, the set temperature
fl ashes to display for 5s. In the fl ashing period, press « + » or « - » button to
adjust the set temperature.
Press «FAN» button to adjust the fan speed. If the set temperature and the
fan speed haven't been adjusted during that time, the remote controller and
the indoor unit will operate under current set temperature and fan speed for
20 minutes. 20 minutes later, the set temperature and the fan speed for the
remote controller and the indoor unit will turn to the status before quick cooling.
NOTE
• If the set temperature and the fan speed have been adjusted during the
operation under fast cooling mode, the unit will exit from the fast cooling
mode. Then the indoor unit operates continuously under the adjusted
status.
• Fast cooling function is only applicable for some models. If this function
is unavailable for this indoor unit, 20 minutes later, the remote controller
will turn back to the status before fast cooling. Indoor unit operates
continuously according to current status. At this time, status of indoor unit
and the display status on the remote controller may be different.
I SENSE
11 button
Press this button to start I SENSE function and «
remote controller. After this function is set, the remote controller will send the
detected ambient temperature to the controller and the unit will automatically
adjust the indoor temperature according to the detected temperature.
status will switch to off status
» will be displayed on the
18
GB