Toyotomi CTN-228W User Manual page 21

main unit setting temperature will increase 1 , two hours, setting temperature
increased 2 , then the unit will run at this setting temperature; In Heat mode:
sleep status after run for one hour, the setting temperature will decrease 1 ,
two hours, setting temperature will decrease 2 , then the unit will run at this
setting temperature.
Sleep 2 is Sleep mode 2, that is air conditioner will run according to the
presetting a group of sleep temperature curve.
Sleep 3 the sleep curve setting under Sleep mode by DIY.
(1) Under Sleep 3 mode, press «SELF CLEAN» button for a long time, remote
controller enters into user individuation sleep setting status, at this time,
the time of remote controller will display «1hour», the setting temperature
«88» will display the corresponding temperature of last setting sleep curve
and blink
(The fi rst entering will display according to the initial curve setting value of
original factory).
(2) Adjust « + » and « - » button, could change the corresponding setting
temperature, after adjusted, press «Turbo» button for confi rmation.
(3) At this time, 1hour will be automatically increase and ed at the timer position
on the remote control, (that are «2hours» or «3hours» or «8hours»),
the place of setting temperature «88» will display the corresponding
temperature of last setting sleep curve and blink.
(4) Repeat the above step (2)~(3) operation, until 8 hours temperature setting
fi nished, sleep,curve setting fi nished, at this time, the remote controller
will resume the original timer display; temperature display will resume to
original setting temperature.
Sleep 3 the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting
sleep curve, enter into user individuation sleep setting status, but do not change
the temperature, press «SELF CLEAN» button directly for confi rmation. Note:
In the above presetting or enquiry procedure, if continuously within 10s, there
is no button pressed, the sleep curve setting within 10s, there is no button
pressed, the sleep curve setting status will be automatically quit and resume
to display the original displaying. In the presetting or enquiry procedure, press
«ON/OFF» button, «MODE» button, «TIMER» button or «SLEEP» button, the
sleep curve setting or enquiry status will quit similarly.
WiFi
16 button
Press «WiFi» button to turn on WiFi function, «WiFi» icon will be displayed on
21
GB