Charging The Battery - SHOWTEC Helix M1100 Q4 Mobile User Manual

Hide thumbs Also See for Helix M1100 Q4 Mobile:
Table of Contents

Advertisement

Helix M1100 Q4 Mobile

Charging the Battery

DANGER
Risk of explosion caused by incorrect handling
This device contains a built-in rechargeable lithium-ion battery. The battery is not replaceable. The
battery may explode or cause burns if it is crushed, disassembled or exposed to fire or high temperatures.
Do not open the device and do not attempt to remove the built-in battery.
To charge the battery follow the steps bellow:
Turn off the power switch (10).
Plug in the True1 pro power
While the battery is charging, the red LED (A) on the left-hand side of the display will light up.
When the battery is fully charged, the green LED (H) on the left-hand side of the display will light up
Connect the AC power adapter to the device. Use only the AC power adapter delivered with the
device.
Connect the AC power adapter to the socket-outlet.
Charge the battery before using the device for the first time.
Do not deep discharge the battery as this will shorten the battery's lifetime. Recharge the battery as
early as possible. Do not let the light run until the battery is depleted.
Make sure that the battery is charged to at least 50 % before storing the device.
Do not charge the lithium-ion battery for more than 24 hours.
Please recharge the battery in time, for example when the battery is (almost) depleted. If you do not
use the Helix for a long time, please recharge the battery at least once a month, in order to prevent
the lithium-ion battery from becoming damaged.
After a cycle use of 300 times, the battery capacity will be reduced to about 8 AH (70% of the total
capacity). Please reduce the charge and discharge times, to extend the battery lifetime. After 300
times of charging and discharging, you need to replace the battery.
Store in the upright position.
It is recommended to charge the device at an ambient temperature between 0 °C and 35 °C.
If the device is charged in a carrying case, leave the case open.
Refer to 3.4. Product Specifications on page 12 for the charge time of the battery.
Note:
You cannot remove the lithium-ion battery and charge it separately. The battery can only be charged
when the device is connected to the mains power.
Product code: 43750
cable.
20

Advertisement

Table of Contents
loading

This manual is also suitable for:

43750

Table of Contents