Dmx Fail; Working Time - SHOWTEC Helix M1100 Q4 Mobile User Manual

Helix M1100 Q4 Mobile

DMX Fail

In this menu you can set the device's behavior in case of a DMX failure.
01) Press the UP/DOWN buttons to set the desired DMX Fail option. Choose one of the 4 options:
● OFF: The device will black out the light output
● HOLD: The device will use last properly received DMX signal, ensuring undisrupted performance
● MANUAL: The device will switch to Manual mode
● PROGRAM: The device will run the built-in programs
02) Press the SET button to confirm your choice.

Working Time

In this menu you can set the working time.
01) Press the UP/DOWN buttons to set the desired working time. Choose one of the 16 options:
● OFF: Turns off the working time setting and the device runs at maximum power, until the battery
is depleted.
● 1–15H: Unit working hours, that means limited power operation based on current battery
capacity
02) Press the SET button to confirm your choice.
Note:
After the working time is set, the maximum operating power of the device will be limited, according to
the current capacity of the battery, to achieve the set working time.
However, if the capacity of the battery is too low, the set time is too long and the working time is not
sufficient, then it will run at the minimum power, and the specific time will be shorter than the set time. If
the battery capacity is sufficient to perform for the desired amount of time, the device will run at the
maximum power, and the working time is uncertain, which may be longer than the set time.
Product code: 43750
39