System Start-Up Procedure - Toshiba MA-600 Programming Manual

4. SYSTEM START-UP PROCEDURE

4. SYSTEM START-UP PROCEDURE
Case 1: To start-up using the MA-600 terminal only
RAM Clear (Chapter 5)
All the programming operations required
for the terminal (Chapter 6)
Case 2: To start-up by installing programming data from the PC
CAUTION!
< Precautions for connection to PC >
1. The USB cable should be connected to the ECR each time a PC sends/receives data to/from the ECR.
If the USB cable is kept connected to the ECR for a long period of time, data transfer may not be
performed properly.
2. When the ECR is connected to a PC with the USB cable, be sure to turn on the ECR in any mode other
than BLIND mode. Otherwise, the ECR may not start.
RAM Clear (Chapter 5)
PC Transmission Information Setting
(See the next page.)
Turn off the ECR.
Connect a PC to the ECR via the USB
cable.
Turn on the ECR in any mode other than
BLIND mode.
DLL (Down Line Loading) the data
programmed on the PC to the terminal.
Perform this setting only for selecting
any other than the default value.
For details, refer to the MA-600 Series
PC Programming Tool Manual.
4- 1
EO3-11106
4. SYSTEM START-UP PROCEDURE