Special Rounding Process Setting, 2-Digit Type - Toshiba MA-600 Programming Manual

6. TERMINAL FILE PROGRAMMING
6.40

Special Rounding Process Setting, 2-digit type

For Special Rounding and Denmark rounding, the pre-rounded value of the two least effective digit and the post-
rounded value are set here. This operation is effective when the option "Special Rounding ACTIVE" and "2 digits
subject to Special Rounding" are selected (System Option Address No. 33, Bit No. 3 SET & Bit No. 4 SET).
CONDITION
Any time outside a sale
OPERATION
Mode Lock: SET
1) Menu Tree
2) Operation Flowchart
Depress [↓] five times then [Enter].
Depress [↓] six times then [Enter].
Maximum value of the range of the digit
*
subject to round (2 digits)
Post-rounded value (2 digits)
NOTES:
1. When the "Post-rounded Value" is to be 100 (i.e. the final break point), the break entry is automatically set
(refer to the example below). Therefore, it does not need to be entered. Entering a value larger 99 for the
Post-rounded value will not cause an error. However, the rounding process will occur only on the two least
effective digits in sales entries.
2. A maximum of 10 breaks can be programmed.
3. Values for Sweden rounding are set after performing a RAM Clear.
4. Example of Sweden rounding
For the Sweden rounding, the amount total is rounded as shown below.
Pre-rounded value of the
two least effective digits
0 to 24
25 to 74
75 to 99
Main Menu
or
Depress [6].
or
Depress [7].
+
[Enter]
[End]
Post-rounded value
00
50
100
6-163
6.40 Special Rounding Process Setting, 2-digit type
ECR is being outside a sale and in SET mode.
"6 OTHER" is selected.
"7 ROUND TBL 2 DIGITS" is selected.
Maximum value of the range of the digit subject to round: 00 to 99
Post-rounded value: 00 to 99
This setting is ended. A long receipt is issued and the display
returns to Main Menu screen.
*: Repeat for the next break entries (max. 10 breaks).
EO3-11106