Atlantic Ultraviolet Bio-Logic BIO 1.5 Installation Operation & Maintenance

Germicidal ultraviolet water purifiers

Advertisement

Quick Links

Models
BIO 1.5
BIO 3.0
Manufacturers / Engineers / Sales / Service
Germicidal Ultraviolet – Equipment & Lamps
375 Marcus Boulevard, Hauppauge, NY 11788
(631) 273-0500 • Fax: (631) 273-0771
Email: Sales@AtlanticUV.com
Shop Products at
AtlanticUltraviolet.com
———————————————
Learn More at Ultraviolet.com
Document No. 98-1523F4 • July 2022 • ©2022 Atlantic Ultraviolet Corporation
Ballast
120v 50/60 Hz
230v 50/60Hz
10-0518A
10-0518A
Installation,
Operation &
Maintenance
Read and Follow All
Safety Instructions.
Save These Instructions.
®
Ballast
10-0514A
10-0514A
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Bio-Logic BIO 1.5 and is the answer not in the manual?

Questions and answers

Summary of Contents for Atlantic Ultraviolet Bio-Logic BIO 1.5

  • Page 1 Germicidal Ultraviolet – Equipment & Lamps 375 Marcus Boulevard, Hauppauge, NY 11788 (631) 273-0500 • Fax: (631) 273-0771 Email: Sales@AtlanticUV.com Shop Products at AtlanticUltraviolet.com ——————————————— Learn More at Ultraviolet.com Document No. 98-1523F4 • July 2022 • ©2022 Atlantic Ultraviolet Corporation ®...
  • Page 2: Table Of Contents

    Models BIO 1.5 and BIO 3.0 using ballast no. 10-0518A and 10-0514A. Questions that are not specifically answered by these instructions should be directed to the Factory. Atlantic Ultraviolet Corporation takes all possible precautions when packaging equipment to prevent damage. Carefully inspect and report all damages. Do not install damaged equipment.
  • Page 3: Safety Warnings

    SAFETY WARNINGS • All personnel should be alerted to the potential hazards indicated by the product safety labeling on this unit. • The following conventions are used to indicate and classify precautions in this manual and on product safety labeling. Failure to observe precautions could result in injury to people or damage to property.
  • Page 4: Caution

    CAUTION It is the user’s responsibility to determine and validate the suitability of this equipment for use in the user’s system or process. No warranty or representation is made by the manufacturer with respect to suitability or performance of this equipment or to the results that may be expected from its use.
  • Page 5: Installation

    INSTALLATION Location The water purifier is intended for indoor use only. The water purifier is designed to mount horizontally. The water purifier should be protected from the elements and from temperatures below freezing. The ambient temperature, in the area surrounding the water purifier, should be between 35°F and 100°F. 2.
  • Page 6: Recommended Installation

    Recommended Installation Figure 2 – Recommended Installation...
  • Page 7: Installation: Bio 1.5 And Bio 3.0 120V 50/60Hz (Ballast No.10-0518A)

    Installation: BIO-1.5 and BIO-3.0 using ballast no.10-0518A 120v 50/60Hz and using ballast no.10-0514A 230v 50/60Hz IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES. Remove water purifier from shipping carton. Inspect water purifier, power cord and plug for damage. Do not operate if there is any damage to the purifier, power cord or plug.
  • Page 8: Recommended Options

    19. Promate Face Shield: Lightweight visor with adjustable headgear provides eye and face protection from ultraviolet rays. NOTE: The recommended options above are available from Atlantic Ultraviolet Corporation or a distributor of their ® products. For the other devices that may be required for your application, please contact your local water treatment...
  • Page 9: Maintenance

    MAINTENANCE The water purifier is designed to operate with a minimal amount of maintenance, providing the water quality does not exceed maximum concentration levels, see “Water Quality” in the “Product Application” section on Page 4. Ordinary maintenance consists of; • Lamp replacement is recommended every 10,000 hours of operation, approximately 12 months of continuous service.
  • Page 10: Lamp Installation Or Replacement: Bio 1.5 And Bio 3.0 120V 50/60Hz (Ballast No.10-0518A)

    Lamp Installation or Replacement BIO-1.5 and BIO-3.0 using ballast no.10- 0518A 120v 50/60Hz and using ballast no.10-0514A 230v 50/60Hz IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES. Figure 4 –...
  • Page 11: Quartz Sleeve Installation, Cleaning Or Replacement

    Quartz Sleeve Installation, Cleaning, or Replacement Figure 5 – BIO-1.5 & BIO-3.0 120v 50/60Hz (ballast no. 10-0518A) Step 4 - Remove Gland Nut From Each End Step 5 - Remove Washer & O-Ring Step 6 - Remove Quartz Sleeve From Each End IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES.
  • Page 12: Replacement Of Broken Quartz Sleeve

    Replacement of Broken Quartz Sleeve Figure 6 – Chamber Head Removal IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES. Broken Quartz is SHARP. It is recommended that protective glasses and gloves are worn when handling. Disconnect power to water purifier.
  • Page 13: Disposal Of Mercury Added Lamp

    Disposal of Mercury Added Lamps Germicidal ultraviolet lamps, like standard fluorescent lamps contain small amounts of mercury. Mercury added lamps should not be placed in the trash. Dispose of properly. For further information regarding the disposal and recycling of lamps containing mercury, along with Federal and State requirements visit LampRecycle.org. For more information on STER-L-RAY Germicidal Ultraviolet Lamps, visit AtlanticUltraviolet.com or Ultraviolet.com.
  • Page 14: Technical Specifications

    TECHNICAL SPECIFICATIONS Table 4 – Technical Specifications Model: BIO 1.5 BIO 3.0 Flow Rate (GPM): Inlet\Outlet Size: 3/8”FNPT 3/8”FNPT Number of Lamps: Lamp Model No.: 05-1366-R 05-1370-R Quartz Sleeve: Length: 14-1/2” 20-1 /8” Width: 3-21/32” 3-21/32” Height: 3-7/8” 3-7/8” Voltage: j 120v 50/60Hz 120v 50/60Hz Chamber Diameter:...
  • Page 15: Replacement Parts

    REPLACEMENT PARTS Figure 7 – Exploded View Table 6 – Replacement Parts BIO-1.5 to BIO-3.0 BIO-1.5 BIO-3 Item No. Description Quantity Rubber O-Ring, Static Gland 00-1108B 00-1108B Steadfast™ Lamp Socket & Surelite™ Ballast, 120v 50/60Hz 10-0518A 10-0518A Steadfast™ Lamp Socket & Surelite™ Ballast, 230v 50/60Hz 10-0514A 10-0514A Steadfast™...
  • Page 16: User Assistance

    WARRANTY & PRODUCT REGISTRATION We warrant this product to the original owner to be free from defects in material and workmanship when installed in accordance with Atlantic Ultraviolet Corporation specifications for a period of time as follows: ®...

This manual is also suitable for:

Bio-logic bio 3.0

Table of Contents