Table of Contents
Advertisement
5.
Operating Components
5.1
Circuit Board
Plug connection
blue
Detail A:
5.2
Jumpers for Setting the Output Signal
If the sensor output signal is set from current to voltage by use of the configuration
software, additionally 2 jumpers must be set on the circuit board as follows:
EE75-TxA6
(for current output, e.g. 4 - 20 mA)
EE75-TxA3
(for voltage output, e.g. 0 - 10 V)
5.3
Jumpers for Setting the Velocity Response Time
The EE75 allows users to set the velocity response time:
a) Setting the velocity response time using jumpers:
Jumper position
No jumper
Jumper at pos. 1
Jumper at pos. 2
Jumper at pos. 3
b) Setting the velocity response time using configuration software:
The response time (τ
configuration software, without changing the jumpers on the circuit board.
See Configuration Software, chapter 4.4 - Response Time
(Also see chapter 5.1 - Circuit Board)
) can also be set to any value between 1.5 and 40 s using the
90
8
Jumper#
Function
I
Current output signal
S
Signal
U
Voltage output signal
1 (arrow)
τ
90-
2
τ
90-
3
τ
90-
4
Free
5
Free
I
S U
I
S U
:
Response time:
1.5 s
2 s
(factory setting)
4 s
(factory setting)
10 s (factory setting)
Jumper
(detail A)
-velocity (2s)
1
-velocity (4s)
2
-velocity (10s)
3
Hardware
Advertisement
Table of Contents
