Kubota KX015-4 Operating Instructions Manual page 70

Operation
If the control lever lock is not raised, the warning light (5) shines yel-
low, the engine cannot be started.
The indicator Pre-glowing (1) lights up briefly. The engine can be
started after it goes off.
The engine oil pressure indicator (3) lights up and goes out after the
engine has been started.
The charge indicator (4) lights up and goes out after the engine has
been started.
If the indicators do not light up when the starter switch is in the RUN
position, remove the key and contact suitably qualified personnel.
If the fuel reserve indicator (2) blinks yellow, there is only a little fuel
is left in the tank, refuel excavator (page 103).
Turn the starter switch to the START position and hold it there until the engine has started. Release the starter
!
switch.
Lower the left control console and make sure that the control lever lock engages.
!
Let the engine run at middle speed until the operating temperature has been reached.
!
After the engine has reached its operating temperature, set the engine speed required for operation:
Pull throttle lever in the direction of
!
The display selector switch (1) allows you to change between the
indication of time, engine speed or hours of operation in the display
(2).
until the required revolutions per minute have been reached
1
6
2
2
3
4
5
1
69