Kubota KX015-4 Operating Instructions Manual page 117

No. Display
12. Pull out Key
No display
13. Lower the control
lever lock
No display
14. Oil pressure too
low
15. Overheat
16. Charging system
error
17. Fuel sensor error
18. Water tempera-
ture sensor error
19. -
20. Lever lock system
error
116
Indicator Problem/Error
The key must be
pulled out.
This message indi-
cates a step in a
procedure.
(yellow)
The engine oil
pressure is too low.
(red)
+
The machine is
overheated and
must cool off by
idling.
The charging sys-
tem has devel-
oped a fault.
(red)
+
The fuel sensor
has developed a
fault; the fuel
gauge does not ap-
(red)
pear in the display.
The coolant tem-
perature sensor
has developed a
fault; the coolant
(red)
temperature gauge
does not appear in
the display.
-
The electrical sys-
tem in the control
lever lock has de-
veloped a fault.
(red)
Preliminary Measure
Pull out Key.
Lower the control le-
ver lock; the indicator
goes out.
Stop the engine imme-
diately. The engine
may have developed
a fault.
Allow the machine to
cool off by idling. Do
not switch the engine
off as the coolant
could then boil over.
Check the V-belt.
When the V-belt is
OK, let the engine run
until indicator goes
out.
Press the display se-
lector switch to return
to the default display.
Press the display se-
lector switch to return
to the default display.
The functions of the
machine are stable
but overheating can-
not be excluded.
- -
The engine can be
started but the ma-
chine cannot be set in
motion.
Troubleshooting
Solution
-
-
Inform your
KUBOTA dealer im-
mediately.
Clean the radiator
and check the cool-
ant, top up if neces-
sary. Check the hy-
draulic system for
leaks; if necessary,
inform your
KUBOTA dealer.
If the indicator does
not go out, inform
your KUBOTA deal-
er immediately.
Inform your
KUBOTA dealer im-
mediately.
Inform your
KUBOTA dealer im-
mediately.
-
Inform your
KUBOTA dealer im-
mediately.