CUMMINS ALLISON JetCount 4020 Operating Instructions Manual page 42

40
Term Definition
Factory Mode
A special set of pre-programmed defaults for the JetCount Setup Fields.
Hopper
The area on top of the JetCount where documents are placed for processing.
Key is used to reset counts to zero. The RESET key is also used to restart the
Reset
machine after a stopping condition.
There are pre-operating conditions that can be assigned or controlled by the
Setup Fields
operator. Once they are set, they remain set (even if the machine is turned OFF)
unless reset by re-entering the setup process.
The area at the bottom front of the JetCount where processed documents are
Stacker
delivered.
Strap
The quantity of documents to be prepared for banding.
JetCount allows the setting of different sensitivity levels per denomination for
Suspect Document
the detection of suspect documents. The lower the sensitivity, the greater the
Sensitivity
opportunity to pass a counterfeit note. The higher the sensitivity, the greater the
opportunity to stop on a good (non-counterfeit) note.
JetCount ® Currency Counter
All Models