Batch Accumulation, Add Key Off - CUMMINS ALLISON JetCount 4020 Operating Instructions Manual

The optional Direct Access Strapping keys give the operator direct access to preset Strap
Limits. To set a strap limit of 50, press a strap key of 50 to produce this screen:
Strap
50
Place currency in the hopper and JetCount will begin counting each note. The machine will add
the value of all the notes based on the chosen denomination key.
JetCount may stop if one of the following conditions occurs: JAM, CHAIN, DOUBLE,
SUSPECT DOCUMENT and STRAP LIMIT. (See
instructions on clearing the condition indicated on the screen.)
JetCount will stop automatically within two seconds when all documents have been run.

Batch Accumulation, ADD Key OFF

Processing currency with the ADD function OFF clears the current count total each time the
stacker is emptied. If you wish to "carry over" counts from one group of currency to the next,
currency should be processed with the ADD function ON.
Assume that a group of notes consisting of $1s, $5s and $10s is to be processed. First, the notes
must be separated by denomination. Then scroll to the $1 screen using the DENOM key or
Direct Access key. Processing the $1s will produce a screen similar to the following:
Strap
100
When the notes are removed from the stacker, count totals will clear and a report will
automatically generate if a printer is enabled.
Assume the notes are left in the stacker, pressing the DENOM key twice or the Direct Access
key prepares the JetCount to process 25 notes. Processing the $5 notes will produce this screen:
Density
* *
0
Count
Stopping Conditions and Recovery Steps
Density
* *
$30
Count
© 2012 Cummins-Allison Corp.
Denomination
$1
* *
Speed
Denomination
$1
* *
Speed
21
for