Memory Levels; Setting Strap Limits - CUMMINS ALLISON JetCount 4020 Operating Instructions Manual

12
multiplier to each note counted. You may use the VALUE key to toggle to the desired
denomination, or press the Direct Access Denomination key. The display will indicate the
denomination selected

Memory Levels

JetCount has two memory levels:
Memory Level
STRAP
BATCH

Setting Strap Limits

JetCount allows you to set individual Strap Limits. For machines with Direct Access
Strapping keys, pre-set Strap Limit Values are set for each key in Setup. Straps may be set for
any piece count between 1 and 100. There are eight preset strap levels: 5, 10, 20, 25, 50, 75, 100
and infinity. Repeatedly pressing STRAP allows you to select among the eight values. The
following screen shows the strap set to"50" in COUNT mode.
To select a Strap Limit between 1 and 100 that is not a preset quantity (e.g., "30"), press and
hold STRAP until the display shows the preset level nearest and below the desired number. If
you continue to hold down STRAP, the value will increase in single-digit increments until you
reach the desired level.
.
Strap Limits can be set at any number between 1-100 and infinity. JetCount
stops when reaching the Strap Limit.
Batch tracks all documents processed when the ADD key is activated, until
cleared.
Strap
50
JetCount ® Currency Counter
Description
Density Denomination
* * COUNT
0 * *
Count
All Models
Speed