Table of Contents
Advertisement
Power
High voltage inside. Risk of electric shock.
Turn power OFF and unplug power cord from machine before cleaning.
Do not attempt repairs. Repairs must be made by authorized Cummins-
Allison Corp. personnel.
Plug three-prong grounded plug (supplied) into properly grounded three-
prong outlet.
Read and understand all instructions before use.
To turn JetCount ON, press the switch located in the lower right rear corner when facing the
front of the machine. JetCount defaults to the mode and settings when last turned OFF.
Hopper
Machine is auto-start capable. Feed rollers in hopper rotate inward.
Entanglement and drawing-in hazard.
Do not operate with exposed long hair, neckties, jewelry or loose
clothing.
The hopper is the area on top of the JetCount where documents are placed for processing.
Density Operation
Density is used to set doubles detection sensitivity for currency and food stamps. Though
adjusting this sensitivity is not a part of configuring the setup fields, it should be adjusted before
processing currency (VALUE mode).
To adjust density for currency, the machine must be in a "normal time-out" status. The current
density setting is the value the machine was set at the last time it was used. Press DNSTY. The
indicator in the middle of the top line of the display (under Density) will move through four
density settings: * , ** , *** and OFF.
If JetCount is detecting doubles frequently, scroll to a lower (less sensitive) setting by pressing
DNSTY.
If JetCount is frequently passing doubles, scroll to a higher (more sensitive) setting. You may
disengage doubles detection for individual denominations by turning the density setting to OFF.
To save changes to density settings in normal operating mode, run the motor (by
pressing RESET or running notes) after changes are made and prior to turning the
machine OFF.
The Basics
© 2012 Cummins-Allison Corp.
9
Hide quick links:
Advertisement
Table of Contents
