Pre-Installation And Application Warnings - Directechs Directed DB3 Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in pricing
accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Important! The following settings must be made for the 2016 - 2019 Chevrolet Malibu Hybrid (Smart Key). The Remote Starters
Š
tachometer setting set Engine Checking Mode to OFF and Cranking Time (in seconds) to 4.0 seconds or similar.
Important!
Š Wait 10 seconds after remote start shutdown before remote starting the vehicle again.
Š Key2GO is mandatory to control the immobilizer override in this firmware.
Š Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Š Refer to the "Vehicle connections" following the installation diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin or if NOT
[2]
supported in data.
Hook up brake for automatic transmission vehicles or clutch for manual transmission vehicles.
[3]
5
403.GM9 2.42 2011 Buick LaCrosse (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
Keys
Keys required
1
required for
for operation
programming
0