Galanz XQG80-Q812DE After-Sales Service Manual page 43

拆除进水位开关
Remove
Water level switch
1.拔掉图一所示水位开
关上三个接线端子
图一 2.将水位开关旋转 90
度后取出
fig.1
1.Unplug the three
terminals of the water
level switch as shown
in figure 1
2. Turn the water level
switch 90 degrees and
take it out
图二
fig.2
拆除进水斗组件
Remove
inlet housing as
XYJGT80QFSDE-001
1.注意水位开关的线组
顺序，重装时注意不要
接错，否则可能引起报
警
1. Pay attention to the
line sequence of water
level switch, and do
not connect wrong
when reinstalling,
otherwise it may cause
alarm
42