Galanz XQG80-Q812DE After-Sales Service Manual page 20

不同测试程序之间通过程序选择旋钮切换。
When the program enters the service mode, the door is automatically locked to empty the water in the
cylinder. During the drainage process, all key actions are shielded and the child lock indicator light
flashes at the frequency of 1Hz. When the water is drained, the child lock will be released
automatically, all buttons will be valid, and the current test steps t01～t08 will be displayed. The
program selection knob is used to switch between different test programs.
D-LED/LCD Model：
旋钮位置
Position knob
P01
P02
...
P07
P08
将旋钮旋到 P02 位置，同时按住 K1/K2 键，然后插入电源，显示屏显示"P02" ，按"启动/暂停"键，
进入维修模式；旋转旋钮进入相应的测试程序。
Turn the knob to position P02, press and hold the K1 / K2 key at the same time, then plug in the
power supply ,the display screen shows "P02", press the "start/pause" key to enter the service mode;
turn the knob to enter the corresponding test program.
程序选择旋钮选择测试程序， 按第一次启动暂停键确定选择， 按第二次启动暂停键启动执行当前选定的
测试程序， 按第三次启动暂停键取消当前正在执行的测试程序， 排空筒内积水并且返回到选择测试程序
状态。在测试程序运行过程中，如果旋动程序选择旋钮，程序将排空筒内积水并且返回到测试程序选择
模式。在测试模式下，屏蔽所有错误报警和软件安全保护功能模块，以方便测试程序检测相应功能模块
的工作情况。
The program selection knob selects the test program. Press the first start/pause key to confirm the
selection, press the second start/ pause key to start the currently selected test program, press the
third start/ pause key to cancel the currently executing test program, drain the water in the cylinder
and return to the selected test program state. During the running of the test program, if you turn the
program selection knob, the program will drain the water in the cylinder and return to the test program
XYJGT80QFSDE-001
测试代码显示
Test code display
t01
t02
...
t07
t08
19