Min. Framing Dims. - Rear Vent Configuration - Travis Industries 564 SS Installation Manual

12
Minimum Framing Dimensions - Rear Vent Configuration
HINT: place the fireplace so the center
HINT: place the fireplace so the center
line is at least 5" from both vertical framing
line is at least 130mm from both vertical
members at the rear (this allows the vent
framing members at the rear (this allows
to pass through the framing without
the vent to pass through the framing
modfications)
without modifications)
Minimum 865mm Fireplace
Minimum 38" Fireplace
Enclosure Height
Enclosure Height
Route the
electrical line to
a position to the
left rear of the
fireplace.
Travis Industries
Installation
33-1/2"
850mm
36-1/2"
930mm
(for qualified installers only)
Included Firestop (required)
Part # 250-00747
19-1/4"
490mm
4070620
Vent Clearances (8" dia. Vent):
Vent Clearances (205mm dia. Vent):
25mm to the sides, 25mm below, and 1" to the sides, 1" below, and 4" above
100mm above the vent to combustibles.
the vent to combustibles.
Center of Rear Vent
24-1/4"
615mm
32-1/2"
825mm
16-1/2"
420mm
The on/off switch/thermostat wire (if
used) should be routed to a location
near the right front of the fireplace.
100-01199_000