Table of Contents
Advertisement
Quick Links
564 SS Clean Face
Fireplace GSR2 (AU)
WARNING:
If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or loss of
life.
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
DO NOT MODIFY THIS APPLIANCE.
-
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire department.
-
Installation and service must be performed by a qualified installer, service agency or the gas
supplier.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA
only) or mobile home, where not prohibited by local codes.
This appliance is only for use with the type(s) of gas indicated on the rating plate. A
conversion kit is supplied with the appliance.
Owner's Manual
Copyright 2015, T.I.
$10.00
100-01420
Listed by
AS 4553-2008 GMK10022
IAPMO-R&T OCEANA
Operation – Maintenance
Dragon Wholesaling Pty. Ltd.
Unit 4, 16 Lexington Drive
Bella Vista NSW 2153
4150225
Australia
Advertisement
Table of Contents
Related Manuals for Travis Industries 564 Clean Face GSR2
Summary of Contents for Travis Industries 564 Clean Face GSR2
- Page 1 Listed by AS 4553-2008 GMK10022 IAPMO-R&T OCEANA Operation – Maintenance 564 SS Clean Face Fireplace GSR2 (AU) WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
-
Page 2: Introduction
This serial number may be needed in case you require Or, mail your warranty card to: service. Dragon Wholesaling Pty. Ltd. Model: 564 Clean Face GSR2 Unit 4, 16 Lexington Drive Serial Number: Bella Vista NSW 2153 Australia Purchase Date: Save Your Bill of Sale. -
Page 3: Table Of Contents
Heating Specifications Natural Gas Propane Approximate Heating Capacity (in square meters)* Up to 88 Up to 88 Maximum MJ Input Per Hour 21.6 21.6 Heating capacity will vary with floor plan, insulation, and outside temperature. © Travis Industries 4150225 100-01420... - Page 4 Immediately call a qualified vicinity of this heater. service technician to inspect the appliance and to replace any part of the control system and any gas control that has been under water. © Travis Industries 4150225 100-01420...
- Page 5 If the fiber logs become damaged, replace with Travis Industries media. Children and adults should be Travis Industries, Inc. grants alerted to the hazards of high no warranty, implied or stated, surface temperature and should for the installation or...
-
Page 6: Before You Begin
Turn off the main gas supply to the appliance during appliance installation or maintenance. During appliance installation or maintenance or in case of remote control malfunction turn off the main gas supply. © Travis Industries 4150225 100-01420... -
Page 7: Remote Set-Up
TO THE APPLIANCE then press the PRG (Program) button for 10 seconds. The pilot will start to spark repeatedly, signifying all system memory has been cleared. The system will return to its original configuration: a remote will need to be synchronized; and, the system will operate under continuous pilot mode. © Travis Industries 4150225 100-01420... -
Page 8: Location Of Controls
If you wish to adjust the mode settings use the transmitter mode button to adjust the settings (see “Mode Controls” on page 12). The thermostat and burner on/off operating functions will not work on the transmitter. © Travis Industries 4150225 100-01420... -
Page 9: Starting The Fireplace For The First Time
IPI/CPI. NOTE: This icon appears when the appliance is in CPI mode. Press the "UP" button Press the "DOWN" button to activate CPI mode. to activate IPI mode. Figure 4 © Travis Industries 4150225 100-01420... -
Page 10: Remote Operation
NOTE: When the batteries start to get low, the IFC will beep twice whenever a button is pressed. When the batteries are nearly depleted, the IFC will no longer beep. See “IFC Batteries” on page 14). © Travis Industries 4150225... -
Page 11: Manual On-Off / Smart Thermostat / Standard Thermostat
Use the up or appear here. down buttons to adjust the target temperature. Figure 9 NOTE: If the transmitter batteries go dead while in thermostat setting (standard or smart), the appliance will shut off after approximately 24 hours. © Travis Industries 4150225 100-01420... -
Page 12: Mode Controls (Flame, Blower, Light, Comfort Control)
When in Manual Mode the blower will remain on, even if the burner is turned off and the heater cools. Either manually turn the blower off, or turn off the heater by pressing the On/Off button. © Travis Industries 4150225... -
Page 13: Mode Controls - Continued
(2 settings). darkened. Figure 14 Display Fahrenheit or Celsius With the system in the “OFF” position, press both the MODE and THERMOSTAT buttons simultaneously to toggle between Fahrenheit (F) and Celsius (C). Figure 15 © Travis Industries 4150225 100-01420... -
Page 14: Low Battery Indicator
Figure 17 Power Outages The remote will work if household current (AC power) is disconnected. The batteries inside the battery box will continue to power the heater but the accent light and blower will not operate. © Travis Industries 4150225 100-01420... -
Page 15: Child-Proof Feature
This appliance has several areas that reach high temperatures. Dust or other particles on these areas may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if the appliance was left idle for a long period. © Travis Industries 4150225 100-01420... -
Page 16: Maintaining Your Fireplace's
Monitor blower operation. Remove any debris or vegetation near the vent termination. Contact your dealer if any sooting or deterioration is found near the vent termination. Venting system should be examined by a qualified agency. © Travis Industries 4150225 100-01420... -
Page 17: Barrier Installation And Removal
Remove the concealment cover. HINT FOR REPLACING THE BARRIER: Hold the barrier at an angle and insert the bottom slots first. Then pivot the barrier forward to engage the top hooks. © Travis Industries 4150225 100-01420... -
Page 18: Glass Frame Removal And Installation
(follow the instructions above in reverse). c) Lift the glass frame slightly and attach the lower latches. NOTE: Make sure the glass frame is all the way in place - it should be flush with © Travis Industries 4150225 100-01420... -
Page 19: Glass Frame Removal And Installation (Continued)
Top of Firebox Glass Frame Anchor Note how the washer on the latch fits behind the flange on the glass frame anchor. Once fully inserted, turn the latch until it is upright. © Travis Industries 4150225 100-01420... -
Page 20: Glass Cleaning
The glass may be cleaned with a non- abrasive cleaner. To clean, remove the glass frame, place it on a non-scratching surface, and clean the inner and outer surface. WARNING: do not operate the fireplace without the glass frame in place. © Travis Industries 4150225 100-01420... -
Page 21: Log Installation
Maintenance Log Installation Log Set Overview When installed, the logs should appear as shown below. Rear Log Right Twig Left Log Left Twig Right Log © Travis Industries 4150225 100-01420... -
Page 22: Rear Log Installation
The rear log has a flat notch on both sides that center it on the grate. Place the rear log on the grate and slide it all the way back until the log contacts the end-brackets on the grate. © Travis Industries 4150225 100-01420... -
Page 23: Right Log Installation
Maintenance Right Log Installation The right log has a groove that fits over the grate. Note how the right side of the log rests on the burner but does not cover any burner holes. © Travis Industries 4150225 100-01420... -
Page 24: Left Log Installation
Maintenance Left Log Installation The left log has a groove that fits over the grate. Note how the right side of the log rests on the burner but does not cover any burner holes. © Travis Industries 4150225 100-01420... -
Page 25: Left Twig Installation
Maintenance Left Twig Installation This hole fits over the pin on the rear log. The left twig should be positioned so the front edge contacts the grate as shown. © Travis Industries 4150225 100-01420... -
Page 26: Right Twig Installation
Maintenance Right Twig Installation The right twig has two holes for the pins on the rear and right log. When in place the right twig will appear as shown above. © Travis Industries 4150225 100-01420... -
Page 27: Ember Installation
Use a stiff brush to apply a thin layer of rockwool fibers onto the burner. Do not use the entire bag of rockwool. Use only a small amount and save the remainder. Over-use of rockwool will diminish the glow and may cause sooting or other adverse conditions. © Travis Industries 4150225 100-01420... -
Page 28: Troubleshooting Table
The bulb may be burned out......... See “Accent Light Replacement” on page Accent Light Does The accent light fuse may be blown...... Not Work Replace the fuse. See fuse location below. Location of fuses: Lights © Travis Industries 4150225 100-01420... -
Page 29: Wiring Diagram
On/Off) Replacement Parts List Caution: Use only Travis Industries replacement parts. Do not use substitute materials. Warning: Do not operate appliance with the glass front removed, cracked, or broken. Replacement of the glass should be done by a licensed or qualified service person. -
Page 30: Conditions & Exclusions
Dragon Wholesaling Pty. Ltd. Unit 4, 16 Lexington Drive Bella Vista NSW 2153 Australia. Dragon Wholesaling warrants this gas appliance (appliance is defined as the equipment manufactured by Travis Industries, Inc.) to be defect-free in material and workmanship to the original purchaser from the date of purchase as follows: Check with your dealer in advance for any costs to you when arranging a warranty call. - Page 31 Limited 7 Year Warranty © Travis Industries 4150225 100-01420...
- Page 32 Intermittent/Continuous Pilot ......9 Starting the Fireplace for the First Time .... 9 Location of Controls ........... 8 Troubleshooting Table ........28 Log Installation ..........21 Wiring Diagram ..........29 Low Battery Indicator ........14 © Travis Industries 4150225 100-01420...