Diffuser Plate Adjustment - Travis Industries 564 SS Installation Manual

Diffuser Plate Adjustment

Certain vent configurations require the diffuser plate to be adjusted (refer to the approved vent
configuration charts for details). Position # 1 is stock (bent). Position # 2 is flattened. See the directions
below to change the diffuser to position #2.
© Travis Industries
Installation
(for qualified installers only)
DIFFUSER SIDE VIEW
Before (Stock - Position # 1)
After (Position # 2)
Bend the round portion of the
diffuser so it is flat (position # 2).
4070620
Remove the exhaust
restrictor.
6mm Nutdriver 1/4" Nutdriver
1/4" Nutdriver
6mm Nutdriver
Remove the diffuser.
Secure the flattened
diffuser plate with the
screws removed earlier.
Replace the exhaust
Replace the exhaust
restrictor (see Exhaust
restrictor (see "Exhaust
Restrictor Adjustment
Restrictor Adjustment"
for restrictor settings).
for restrictor settings).
100-01199_000
25