Operating Procedures; Turning On The Lamp; Turning Off The Lamp - Olympus U-LGPS Instructions Manual

2 2

Operating Procedures

This section describes the basic operating procedures of each portion.
A
B D D
C
B D
C
A
1

Turning ON the lamp

Set the main switch A on the back of U-LGPS to (ON).
1
· The pilot lamp B on the front of U-LGPS turns ON (green).
TIP
· The numeral characters or texts are displayed on the counter
D on the front of U-LGPS.
When using U-LGPS control software:
Turn ON the power of the PC (control PC) where software is installed,
and start the U-LGPS control software.
2 Press the lamp switch C on the front of U-LGPS.
· The color of the pilot lamp B on the front of U-LGPS turns to
TIP TIP
blue.
· Pressing the lamp switch C allows you to select ON or OFF
of the lamp.
· You can check the status of the lamp by the color of the pilot
lamp. For details, see page 12.
2

Turning OFF the lamp

Press the lamp switch C of U-LGPS.
1
· The color of the pilot lamp B turns to green.
TIP
· The cooling fan may keep working for cooling purpose.
When the cooling is finished, the cooling fan stops
automatically.
When using U-LGPS control software:
Turn OFF the power of the control PC.
2 Set the power switch A to
· The pilot lamp B on the front of U-LGPS turns OFF.
TIP
· The numeral characters or texts on the counter D on the
front of U-LGPS disappear.
When using U-LGPS control software:
Turn OFF the power of the control PC.
(OFF).
U-LGPS
11