Festo Sorting Station Inline Operating Instructions Manual page 17

•
Pneumatic circuit setup
–
–
•
Pneumatic circuit dismantling
–
–
•
Noise due to escaping compressed air
–
–
© Festo Didactic 8129444
Connect the components with plastic tubing with an outside diameter of 4 or
6 mm.
Push the tubing as far as it will go into the push-in connector.
Switch off the compressed air supply before dismantling the circuit.
Press the blue release ring down, after which the tubing can be pulled out.
Noise caused by escaping compressed air may damage your hearing. Reduce
noise by using mufflers, or wear hearing protection if noise cannot be avoided.
All of the exhaust ports of the components included in the equipment set are
equipped with mufflers. Do not remove these mufflers.
CAUTION
Sorting Station Inline
17