Power Supply Of External Devices Via Usb Connection Of The Kiox Display - Urban Arrow Family User Manual

2
Switching the bike light on and off has no effect on the back
lighting of the display.
2
Contact your Urban Arrow dealer in case the front and rear
light don't turn on simultaneously or don't turn on at all.
Turning off the lights with the Purion display is done as follows:
1. Press the + button 103 longer than 2.5 seconds to switch on
the lights. The lighting symbol 116 will disappear from the
display.
5.10 Power supply of external devices via USB connection of the
Kiox display
With the USB connection on the Kiox it is possible to operate and
charge most devices whose power supply is possible via USB (e.g.
various mobile phones).
2
The USB connection on the Purion display is only for service
purposes.
6
If electrical loads are connected, this can affect the range of
the eBike.
User manual
Supplying your external device with power via the display is done as
follows:
1. In case you have a Kiox display: Place the display in the
display holder 47. See paragraph 5.6.1 for instructions.
2. Place a charged battery in the battery holder. See paragraph
5.6.2 for instructions.
3. Open the USB port protective cap 81.
4. Connect the USB connection of the external device to the
USB port 80. Use the USB charging cable Micro A – Micro B
(available from your Urban Arrow e-bike dealer).
5. Close the USB port protective cap after disconnecting the
external device.
1
A USB connection is not a waterproof plug-in connection.
Moisture can cause internal damage to the display. Always
completely seal the USB connection with the protective cap
81. Never connect an external device when you ride in the
rain.
2
If the display is switched off during charging via a USB cable,
the display can only be switched on again once the USB cable
has been disconnected.
EN
39