Alert Set Value 1 To; H To; Upper/Lower Output Limiter (Buffer Memory Address: 2A , 2B , 4A , 4B , 6A , 6B , 8A , 8B ) - Mitsubishi Electric MELSEC Q Series User Manual
Hide thumbs
Also See for MELSEC Q Series:
- User manual (834 pages) ,
- Reference manual (674 pages) ,
- Programming manual (624 pages)
Table of Contents
Advertisement
3 SPECIFICATIONS
3.5.16 Alert set value 1 to 4
(buffer memory address: 26
3.5.17 Upper/lower output limiter
(buffer memory address: 2A
3 - 47
Downloaded from
ManualsNet.com
H
(1) Sets the temperature to turn on Alert 1 to 4 mode setting (buffer memory address:
C0
to C3
, D0
H
H
(2) The setting range is within the temperature setting range specified in the Input
range (buffer memory address: 20
(3) Setting a value outside the setting range, or setting other than 0 for the setting
range in mode setting 0 will result in a write error and Write error flag (Xn2) turns
ON.
(4) The set value varies with the setting increments of Input range (buffer memory
address: 20
, 40
H
• If the setting increments(1) without a decimal point is set, the value is set in
increments of 1 degree Celsius.
• If the setting increments(0.1) with a decimal point is set, the value is set in
increments of 0.1 degree Celsius. (The value is indicated without a decimal
point.)
H
(1) Sets the upper and lower limit values for actually outputting the manipulated value
(MV) calculated by PID operation to an external device.
(2) The setting range is -50 to 1050 (-5.0% to 105.0%).
Make setting so that the (lower output limiter value) is less than the (upper output
limiter value).
search engine
to 29
, 46
to 49
, 66
H
H
H
to D3
, E0
to E3
, F0
H
H
H
H
H
, 40
, 60
H
H
, 60
, 80
)(refer to Section 3.5.12) as indicated below:
H
H
H
, 2B
, 4A
, 4B
, 6A
, 6B
H
H
H
H
MELSEC-Q
to 69
, 86
to 89
)
H
H
H
H
to F3
)
H
, 80
) (refer to Section 3.5.12).
H
H
, 8A
, 8B
)
H
H
H
3 - 47
Advertisement
Table of Contents
