Dmx Control; Maintenance; Cleaning The Unit And Maintenance - ProLights NEWMOON User Manual

3.10 DMX control

DMX value Channel 1
000 - 010
011 - 024
025 - 039
040 - 054
055 - 069
070 - 084
085 - 099
100 - 114
115 - 129
Dimming
130 - 144
000-255
145 - 159
160 - 174
175 - 189
190 - 214
215 - 219
220 - 234
235 - 249
250-255

- 4 - MAINTENANCE

4.1 Cleaning the unit and maintenance

• Make sure the area below the installation place is free from unwanted persons during setup.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
• housings, fixations and installation spots (ceiling, trusses, suspensions) should be totally free from any
deformation.
• When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or other
particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the main
plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe the
part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might pen-
etrate the unit and cause damage to it.
Warning: we strongly recommend internal cleaning to be carried out by qualified personnel!
NEWMOON
Channel 2 Channel 3
000-255
Program01
Program02
Program03
Program04
Program05
Program06
Program07
Program08
Program09
Program10
Program11
Program12
Program13
Program14
Program15
Sound activated1
(Master projector)
Sound activated2
(Master projector)
Channel 4
Red Green
000-255
Speed Flash
No use No use
Channel 5 Channel 6
Blue Amber
000-255 000-255
No use No use
11