Functions And Settings; Operation; Setting Of Dip-Switch - ProLights NEWMOON User Manual

6

- 3 - FUNCTIONS AND SETTINGS

3.1 Operation

Connect the supplied main cable to a socket (AC 100/240V, 50/60hz). Then the unit is ready for operation
and can be operated via a DMX controller or it independently performs its show program in succession. To
switch off, disconnect the mains plug from the socket. For a more convenient operation it is recommended
to connect the unit to a socket which can be switched on and off via a light switch.

3.2 Setting of DIP-switch

The NEWMOON has a basic control panel consists of a DIP-switch (fig.3)
Each individual switch has a number (DIP-switch [1] to [10]).
• I DIP-switch [1 - 8] allow setting the values of functions.
• I DIP-switch [9 - 10], instead, allow the settings shown in the following table:
MODE
AUTO RUN
(Master projector)
SELECT PROGRAMS
(Master projector)
SOUND ACTIVATED 1
(Master projector)
SOUND ACTIVATED 2
(Master projector)
SLAVE
DMX
NEWMOON
DIP Switch DIP Switch
[9] [10]
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
ON -
Fig.3
Functions
Select running speed via dip 5 - dip 8
Select 15 built-in programs via dip 1 - dip 4
Select running speed via dip 5 - dip 8
Running one time when activated by sound
each time
Running for 5 seconds when activated by
sound each time
When only dip 10 is on, it is slave
Ch 1: dimming
Ch 2: select programs and sound active
Ch 3: speed
Ch 4: flash