Error Messages/Display Messages - Casio KL-7200E User Manual

Ink ribbon is being fed from the tape outlet along with the tape.
Possible Causes
Ink ribbon cassette Remove the ink ribbon cassette and
loaded while the ink check to make sure the ink ribbon is
ribbon is slack. not broken. Next, take up any slack
in the ink ribbon and then reload the
tape cartridge.
Important!
Tape Cutting
Cannot cut tape.
Possible Causes
Tape cutter blade is dull. Take the label printer to the dealer
from whom you purchased it to have
the tape cutter blade replaced.
Printed text is cut off by tape cut operation.
Possible Causes
The printer is set up for Be sure to press the FUNC FEED key
manual tape feed. before performing the tape cut
operation.
Important!
When the printer is set up for manual
tape feed, the tape is not fed
automatically after printing is complete.
Out of tape Replace the tape cartridge with a new
one.
E-24
Action
Before loading an ink ribbon
cassette into the label printer,
always make sure you take up any
slack in the ink ribbon first.
If the ink ribbon is broken, you
must change to another ink ribbon
cassette.
Action
Action
Using Labels
Page
Possible Causes
The backing paper is still
on the back of the tape.
Surface is unsuitable for
affixing a tape.
E-7

Error Messages/Display Messages

Message
¥
ERROR!
* This message
appears on the
screen for about
one second.
NO DATA
Page
* This message
appears on the
—
screen for about
one second.
OVERWRITE?
Page
E-17
E-7
Label will not adhere to a surface.
Action
Peel the backing paper from the back
of the tape to expose the adhesive.
Labels do not adhere well to surfaces
that are rough, wet, oily, or dirty.
Possible Causes
The number carriage Use wider tape or reduce
returns you input causes the number of lines.
the label to exceed the 6mm tape...1 line
maximum number of lines 9mm tape...1 line
for the tape you are 12mm tape...Up to 2 lines
using. 18mm tape...Up to 3 lines
24mm tape...Up to 3 lines
You are attempting to
recall text from memory
when there is none
stored.
You are attempting to Press SET to overwrite
store text in memory the existing text with the
when it already contains new text, or ESC to
text. cancel the store
operation.
Page
E-16
E-16
Action