Error Messages/Display Messages - Casio KL-120 User Manual

• • • • • Tape Cutting
Cannot cut tape.
Possible Causes
Tape cutter blade is dull. Take the label printer to the dealer
from whom you purchased it to have
the tape cutter blade replaced.
Printed text is cut off by tape cut operation.
Possible Causes
Out of tape Replace the tape cartridge with a new
one.
• • • • • Using Labels
Label will not adhere to a surface.
Possible Causes
The backing paper is still Peel the backing paper from the back
on the back of the tape. of the tape to expose the adhesive.
Surface is unsuitable for Labels do not adhere well to surfaces
affixing a tape. that are rough, wet, oily, or dirty.
E-26
Action Page
—
Action Page
E-9
Action Page
E-18
E-18

Error Messages/Display Messages

Message Possible Causes
• The number carriage
TOO MANY
LINES! returns you input causes
the label to exceed the
maximum number of lines
for the tape you are
using.
• You are attempting to
NO DATA!
recall text from memory
when there is none
stored.
• You are attempting to
OVERWRITE?
SET/ESC store text in memory
when it already contained
text.
• You are attempting to
LOAD A TAPE
CARTRIDGE perform printing without
setting a tape cartridge.
* This message
also appears
when the tape
cartridge is
loaded correctly,
but "NONE" is
selected for the
tape width.
• Battery power is low.
LOW BATTERY!
• This message appears
LONGER THAN
SET! when the length of the
SET/ESC tape that will actually be
printed is longer than the
specified tape length.
Action
• Use wider tape or reduce
the number of lines.
6mm tape...1 line
9mm tape...1 line
12mm tape...Up to 2 lines
18mm tape...Up to 2 lines
• Store the text in memory
and then try again.
• Press SET to overwrite
the existing text with the
new text, or ESC to
cancel the store
operation.
• Turn the power OFF and
set the tape cartridge.
• Replace the batteries.
• To print, press SET.
• To cancel printing, press
ESC. You can then
decrease the number of
characters, change to a
longer tape setting, or
select auto tape length.