Bar Code Specifications; Troubleshooting - Casio KL-7200E User Manual

Bar Code Specifications

Bar code Check Print
Type Digit *1 Digit *2 Digits *3
EAN-13 Yes 13
EAN-8 Yes 8
*1 The check digit is automatically calculated in accordance with input data.
For EAN-13 and EAN-8, the check digit is appended at the end of the printed
digits.
*2 The number of digits printed below a bar code equals the input characters
plus automatically appended characters.
*3 An error message is displayed whenever there are insufficient digits. The
unit will not allow input of too many digits.

Troubleshooting

Power Supply
Nothing appears on the display.
Possible Causes
Low batteries Replace batteries.
Improper display contrast Adjust display contrast.
setting
Batteries loaded Remove batteries and reload them
incorrectly correctly.
AC adaptor is not Make sure the AC adaptor is
connected correctly. connected correctly.
Text Input
Cannot input text.
Possible Causes
FUNC key has been Press ESC to clear FUNC key
pressed. operation.
Automatically
Input Assigned Input
Number of Digits Characters
(Check Digit *1)
12 1 Numerals (0 ~ 9)
7 1 Numerals (0 ~ 9)
Action
Action
Tape does not come out when PRINT is pressed.
Possible Causes
Tape cartridge
compartment cover is not
closed completely.
No more tape left in the
cartridge.
Tape jam
Tape comes out when PRINT is pressed, but nothing is printed on it.
Possible Causes
Only blank spaces were
Page
input.
E-6
Printing is blurred, blotched, broken, etc.
E-21
Possible Causes
Improper print density
E-6
setting
Improper loading of the
E-7
cartridge
Dirty printer head or
rubber roller
Page
E-9
Action
Securely close the cover.
Replace the tape cartridge with a
new one.
Remove the tape cartridge and pull
out the jammed tape by hand. Cut off
excess tape with scissors, and
carefully replace the cartridge into
the label printer.
Important!
Never allow the tape outlet to
become blocked and never touch
tape as it is being fed during printing.
Action
Input the text you want to print.
Action
Adjust the print density setting.
Remove the tape cartridge and
reload it correctly.
Clean the printer head and roller.
Page
E-7
E-7
E-7
Page
E-9
Page
E-17
E-7
E-21
E-23