Registering The Module - Toshiba nv Series User Manual

Appendix C Registration and Setup Procedure (Engineering Tool Ver.4)
C.1 Registering the Module
Figure C-1 shows an example of a system to be registered and setup.
(1) Open the Engineering tool product tree.
(2) Register the system. Register the system (Profibus) in Figure C-1.
(3) Register the station. Register two stations as nv light station (PF611ATEST and
PF612ATEST) in Figure C-1. Then register two dummy stations as other station
(PF611ADMY and PF612ADMY).
Note1: PROFIBUS-DP is a master/slave type network and does not a have station common
(4) Select the system (Profibus) station (PF611ATEST).
(5) Register BU648E as the basic system.
(6) Register "PUM11" in "0 slot" and "PF611" in "1 slot" of the base unit.
(7) Also register "PUM11" and "PF612" in the base unit (BU648E) of the station
(PF612ATEST) in the same manner.
(8) Register "PFStn" as the unit and "PF_x" as the module of the dummy station
(PF611ADMY).
(9) Register "PFStn" as the unit and "PF_x" as the module of the dummy station
(PF612ADMY).
6F8C1872
48
BU648E
Station : PF611ATEST
NODE No. : 1
Send words : 8 words
Receive words : 8 words
Figure C-1 Registration and setup sample system
transmission image as with TOSLINE-S20 or FL-net. Therefore, common network
variables cannot be registered when connecting PF611A and PF612A. To resolve this
situation, assume that they are connected to a separate PROFIBUS-DP LAN and
register a dummy station in each LAN. (See Figure C-2) This is the same when
connecting PF611/PF612/PF311/PF312. If the connected master and slave are non-
Toshiba modules, simply register as other station because there is no concept of
network variable on the destination node.
BU648E
System :
Profibus
Station :
NODE No. :
Send words :
Receive words : 8 words
PF612ATEST
2
8 words