07/15 Rev. 00
Status messages on the dispenser
Error messages
When an error occurs, the dispenser stops immediately and shows an error
message on the control panel.
Error messages are based on the following outline:
a)
b)
To delete an error message:
1. Rectify the cause of the fault. For further details see section
2. Press the
Error messages that are not described below can only be rectified by qualified
service personnel.
If an error that is not described here occurs:
1. Press the
2. Switch off the device, wait for 30 seconds and switch it on again.
Warnings
Warnings refer to states less critical than error messages.
Labelling operation is not interrupted by a warning.
Warnings may occur in dispensing mode or in online settings mode.
Warnings are based on the following outline:
a)
SERVICE MANUAL
Status num:
5144
b
Rewinder init
5144 = The status number. This number is an easy
way to identify the message.
"Rewinder init" = Status text; brief description of the
error.
messages
on page 5.
key to delete the message.
key to delete the message.
ONLINE
a
Material warning
"Material warning" = brief description depending on
what triggered the warning.
While a warning is being displayed, the "Warning" signal output is
active.
ALX 73x
a
Dispenser status
Status messages on the dispenser
List of error
2