Table of Contents
Advertisement
outputs a continuous waveform after receiving trigger signal.
Press [Burst] >Type softkey to select "Inf Cycle".A schematic diagram of infinite cycle pulse will
be displayed on the screen.
For Infinite Cycle mode, the trigger source includes "Internal", "External" or "Manual". Besides,
users can set the "Phase", "Count" and "Trigger Slope" (external trigger) and "Trigger" (manual
trigger).
GatedBurst
In Gated Mode, the generator controls the waveform output according to the external signal level
from the[FSK/Trig/Sync/Extmod] connector on the rear panel.
Press[Burst] >Type softkey to select"Gate"and then press Polarity to set the gated polarity as
"Positive" (or "Negative"). The generator outputs burst waveform only when the gated signal is
"Positive" (or "Negative").
When the gated signal is "True", the generator outputs a continuous waveform; when the gated
signal is "False", the generator completes the current period, and then stops and holds on the
voltage level corresponding to the initial burst phase of the selected waveform. For Noise
User Manual
62
Advertisement
Table of Contents
