Sanyo DSR-3016 Instruction Manual page 68

RECORDING SETTING
MOTION SENSOR setting
(default setting: OFF)
To display motion sensors on each camera image and make settings
for intruder detection. The motion sensors work as shown below.
1 2
3 4 5
1
Motion sensor off status
When the jog dial is turned, the cursor moves.
2
Sensor setting
Turn the shuttle dial clockwise to select "A", "B" or "– ". Select "A"
or "B" in accordance with the sensor sensing position.
If setting the sensors one line at a time, move the cursor to the line
to be set and then press "MENU RESET" and select "A", "B" or "– ".
3
Camera display
When the camera select button is pressed, the camera number
changes. Use the camera select button to select cameras that are
set for motion sensor alarms.
4
Setting motion sensor operating times
Use TIME PERIOD SET to select specified time zones (T-1 to 4).
This will enable an alarm to be detected by motion sensors with
specified sensitivities only in the selected time zones
(See page 46).
5
Motion sensor sensitivity setting
This sets the sensor sensitivity.
1, 2, 3, 4 ... (the higher the number, the lower the sensitivity),
OFF
6
Motion sensor detection setting
A: A motion sensor alarm is generated when a moving object
is detected at A.
A AND B: When an object is detected touching both sensors
at point A and point B, a motion sensor alarm will be triggered.
A AND NB: With point A aligned on an important item (object)
and point B aligned on a non-moving object, a motion sensor
alarm will be triggered when the object at point A is detected,
without reacting to changes such as the brightness of the
whole screen.
B TO A: A motion sensor alarm will be triggered if there is any
change in the movement of a subject passing from point B to
point A.
C: A motion sensor alarm is generated when the whole screen
area changes uniformly. This results in a reaction at times such
as when the camera is sprayed with something. (Sensor
settings are not required.)
7
EXIT
When this is selected, the display returns to the previous screen.
English
2
6 7
MENU
1
After changing the TIMER A and TIMER B settings in the TIME
PERIOD SET menu, select MOTION SENSOR. (See page 46.)
2
Press the MENU button to select RECORD SET, and then turn
the shuttle dial clockwise.
The RECORD SET sub-menu appears, and the cursor is
positioned at RECORDING AREA SET.
3
Use the jog dial to move the cursor to ALARM OPERATION
SET, and then turn the shuttle dial clockwise.
The ALARM OPERATION SET sub-menu appears, and the cursor
is positioned at MAIN MON. DISPLAY.
4
Use the jog dial to move the cursor to MOTION SENSOR, and
then turn the shuttle dial clockwise.
The motion sensor setting screen is displayed.
5
Press a camera select button (example: 5).
Select the camera number for the camera to use for setting the
motion sensor.
5
6
Use the jog dial to move the cursor to the center of the
screen, and then turn the shuttle dial clockwise so that " A" is
displayed.
Use the same procedure to display "A" in the center of the screen.
67