Sanyo DSR-3016 Instruction Manual page 70

RECORDING SETTING
5
Repeat the above procedure to set the alarm duration for
other cameras.
6
Press the EXIT/OSD button.
The display returns to the normal screen.
EXIT/OSD
English
Resetting an alarm
When images from the camera where the alarm
was detected are appearing in a single-screen
display
1
Press the camera select button for the camera that is being
shown in the single-screen display for approximately
3 seconds.
The alarm will then be canceled.
4
When images from the camera where the alarm
was detected are displayed in a multiple-screen
1
Press the camera select button for the camera that is showing
the alarm.
The alarm images will appear in a single-screen display.
4
2
Press the camera select button again for approximately
3 seconds.
The alarm will then be canceled.
4
Note: Alarms can also be reset by using the ALARM RESET button
on the rear panel of the digital video recorder.
69