Sanyo DSR-3016 Instruction Manual page 63

RECORDING SETTING
Pre-alarm recording setting
1
Use the jog dial to move the cursor to ALARM RECORDING,
and then turn the shuttle dial clockwise.
"OFF" flashes.
2
Use the jog dial to change the " OFF" setting to some other
mode (example: ENABLED), and then turn the shuttle dial
clockwise.
The PRE-ALARM RECORDING setting changes from "***" to
"OFF".
The cursor moves to REC RATE.
3
Use the jog dial to move the cursor to PRE-ALARM
RECORDING, and then turn the shuttle dial clockwise.
"OFF" flashes.
4
Use the jog dial to change from " OFF" to " ON" , and then turn
the shuttle dial clockwise.
An automatic speed adjustment warning message will be
displayed.
5
Turn the jog dial to select " YES" in the warning message
window, and then turn the shuttle dial clockwise.
6
Turn the jog dial to select "DURATION" and then turn the
shuttle dial clockwise.
The cursor moves to the "5SEC" setting for DURATION and
flashes.
7
Use the jog dial to set the recording time duration (example:
" 10SEC" ), and then turn the shuttle dial clockwise.
The cursor moves to ALARM TRIGGER.
8
Use the jog dial to move the cursor to PROGRAM GROUP,
turn the shuttle dial clockwise, use the jog dial to set the
program number (example: " P-1"), and then turn the shuttle
dial clockwise.
The cursor moves to REC RATE.
Display examples:
OFF: Pre-alarm images from all cameras are recorded at the
same recording speed.
P-1: When program no. 1 is recorded
P-2: When program no. 2 is recorded
P-3: When program no. 3 is recorded
P-4: When program no. 4 is recorded
Note: When pre-alarm recording has been set, the pre-alarm
recording speed and the recording speed for normal recording
will be fixed at 15 FPS. A warning screen appears to verify
confirm this, so select "YES".
9
Press the EXIT/OSD button.
The display returns to the normal screen.
"PRE" appears in the operating display section. When an alarm is
triggered, the display switches to "ALARM".
EXIT/OSD
Note:
Pre-alarm recording continues for the length of time specified by
the DURATION setting before an alarm signal is input. When
playing back images that have been recorded during pre-alarm
recording, use the alarm search (SEARCH button) operations.
Images will be played back from the point that the alarm occurred,
so use the shuttle operations to carry out rewind playback.
If carrying out normal alarm recording and pre-alarm recording at
the same time, no audio signals will be recorded with the
pre-alarm recording images.
62
English