Sanyo DSR-3016 Instruction Manual page 48

INITIAL SET MENU
Operable functions during the period set
by the timer
Each of the following menu settings is required to operate these timer
functions. After you have made the menu settings, be sure to make
the timer settings.
To change camera images into automatic switching
screens.
Set "SEQUENCE" on SCREEN SET screen
To hide camera images with a gray pattern
Set the "MASK" setting in the SCREEN SET menu.
To detect an alarm input in a camera image
Set "MOTION SENSOR" on ALARM OPERATION SET screen
For these settings, set Example 2 consecutively with Example 1.
Example 1: Set TIME PERIOD A and TIME PERIOD B
time zones as follows
(TIME PERIOD A settings)
T1 4 a.m. (4:00)
T2 6:30 a.m. (6:30)
T3 12:30 p.m. (12:30)
T4 6 p.m. (18:00)
MENU
English
(TIME PERIOD B settings)
T1 6 a.m. (6:00)
T2 8 a.m. (8:00)
T3 2:30 p.m. (14:30)
T4 8 p.m. (20:00)
1
Press the MENU button to select INITIAL SET, and then turn
the shuttle dial clockwise.
The INITIAL SET sub-menu appears, and the cursor is positioned
at LANGUAGE/CLOCK SET.
2
Use the jog dial to move the cursor to TIME PERIOD SET, and
then turn the shuttle dial clockwise.
The TIME PERIOD SET sub-menu appears.
3
Turn the jog dial to select TIME PERIOD A, and then turn the
shuttle dial clockwise.
Note: This can also be set using the numeric keys. (See page 43.)
"00" (hour) flashes in the "T1" column.
4
Turn the jog dial to change the T1 setting to " 04" (hour), and
then turn the shuttle dial clockwise.
"00" (minutes) flashes in the "T1" column.
5
Turn the jog dial to change the T1 setting to " 00" (minutes),
and then turn the shuttle dial clockwise.
"00" (hour) flashes in the "T2" column.
6
Turn the jog dial to change the T2 setting to " 06" (hour), and
then turn the shuttle dial clockwise.
"00" (minutes) flashes in the "T2" column.
7
Turn the jog dial to change the T2 setting to " 30" (minutes),
and then turn the shuttle dial clockwise.
"00" (hour) flashes in the "T3" column.
Repeat steps 3 to 6 to set the hours and minutes for T3 and T4.
8
Repeat the above procedure to set the hour and minutes for
T1, T2, T3 and T4 for TIME PERIOD B.
Note: If T1 is set to "00:00", it is regarded as midnight, and if T2 to T4
are set to "00:00", they are skipped regardless of the time. If T1
to T4 are all set to "00:00", only T1 is regarded as valid, and
the timer will operate from midnight on the start day until the
following midnight.
47