Mounting The Probe On A Shank (Or Machine Table) - Renishaw RMP60 Installation Manual

RMP60 installation guide
Mounting the probe on a shank (or
machine table)
1
3.6
2
Bobbin
(A-4038-0303)
(x 4)
NOTE: In instances where the
RMP60 is to be used with a shank
switch, it will be necessary to
remove the plug from the rear of
the probe using pliers. This should
then be substituted with the bobbin
(A-4038-0303).
3
(x 2)
(x 2)
2 Nm – 3 Nm
(1.5 lbf.ft – 2.2 lbf.ft)