Table of Contents
Advertisement
OMP600 installation guide
Mounting the probe on a shank
NOTE: In instances where the OMP600 is to be used with a shank switch, it will be necessary to
remove the plug from the rear of the probe using pliers. This should then be substituted with the bobbin
(A-4038-0303).
3.6
1
2
Bobbin
(A-4038-0303)
2.5 mm A/F
× 4
3
4.0 mm
A/F × 2
× 2
0.5 Nm – 1.5 Nm
(0.4 lbf.ft – 1.1 lbf.ft)
Advertisement
Table of Contents
