Sanus Systems Motorized Mount LA112 Installation Manual page 10

Avoid potential injuries and / or property damage! Do
not use the monitor manufacturer's "screen size"; you
must measure the width of the monitor case, including
any speakers attached to the sides.
The LA112 restricts movement based up on the TV
widteh set on the side controls. The TV widthe must be
set correctly before operating the LA112.
To set the monitor width, determine the correct code from
the chart below.
Insert the power cord [08] into the plug on the arm assembly,
then connect the power cord to a grounded outlet.
Turn the power switch [a] to the ON position. Insert the
selector pin [07] into the receptacle [B] and press until the
correct code is displayed.
Press and hold the "Set" button [C] until the display stops
blinking to accept the code.
CODE WIDTH
C1 102 - 113 cm (40 - 44.9 in.)
C2 114 - 123 cm (45 - 48.9 in.)
C3 124 - 140 cm (49 - 55.9 in.)
C4 141 - 155 cm (56 - 61.0 in.)
Selector
[B]
[C]
Set
5: Set the Monitor Width
CauTION
CauTION
Measure monitor width,
including any speakers
[a]
[08]
6901-100189 <01>
[07]