14 European Standards
*1
For circuit protection, the main circuit is separated from the surface case that can touch the main circuit.
*2
To comply with LVD standard requirement, set L8-05 = 1 [Input Phase Loss Protection Sel = Enabled] to protect the drive from the high
current caused by Input Phase Loss condition.
*3
Use braided shield cable for the drive and motor wiring, or run the wiring through a metal conduit.
72
Figure 14.2 Wiring Diagram for CE Low Voltage Directive Compliance
YASKAWA TOEPC7106171GA FP605 Drive Installation & Primary Operation