Control Circuit Terminal Block Functions; Input Terminals - YASKAWA FP65U T Series Installation & Primary Operation

Table of Contents

Push

• [No]: The keypad will not show the Initial Setup Screen when the drive is energized.

• [Yes]: The keypad will show the Initial Setup Screen when the drive is energized.

◆

Control Circuit Terminal Block Functions

Hx-xx parameters set functions for the multi-function input and output terminals.

WARNING

Sudden Movement Hazard. Correctly wire and test all control circuits to make sure that the control circuits operate

correctly. If you use a drive that has incorrect control circuit wiring or operation, it can cause death or serious injury.

WARNING

Sudden Movement Hazard. Check the I/O signals and the external sequences for the drive before you set the

Application Preset function. When you set the Application Preset function (A1-06 ≠ 0), it changes the I/O terminal functions for the

drive and it can cause equipment to operate unusually. This can cause serious injury or death.

NOTICE

Damage to Equipment. Do not energize and de-energize the drive more frequently than one time each 30

minutes. If you frequently energize and de-energize the drive, it can cause drive failure.

NOTICE

Damage to Equipment. Do not cycle the Main Switch more than 6000 times. If you cycle the Main Switch more

times than the limit, it will cause the contact failure, or you cannot open or close the Main Switch.

NOTICE

Damage to Equipment. Make sure that you stop the motor before you turn ON/OFF the Main Switch. If you turn

ON/OFF the Main Switch during run, it can cause Main Switch failure.

■

Refer to

Table 11.1

for a list of input terminals and functions.

YASKAWA TOEPC7106171GA FP605 Drive Installation & Primary Operation

to select [Show Initial Setup Screen], then push

to select [No], then push

11 Drive Start-Up Procedure

Table of Contents

Fp605