Trigger; Abort; Initiate:continuous[?] Off - R&S NRP-Z27 Operating Manual

R&S NRP-Z27/-Z37

TRIGger

Table 6-8 Commands of the TRIGger system
Command

ABORt

INITiate
:CONTinuous[?]
:IMMediate
TRIGger
:COUNt[?]
:DELay[?]
:AUTO[?]
:HOLDoff[?]
:HYSTeresis[?]
:IMMediate
:LEVel[?]
:SLOPe[?]
:SOURce[?]
ABORt
ABORt interrupts the current measurement and sets the power sensor module to the IDLE state
(normal case). However, if the power sensor module is in the continuous measurement mode (setting
INITiate:CONTinuous ON), the IDLE state is immediately exited and the power sensor module enters
the WAIT_FOR_TRIGGER state.
INITiate:CONTinuous[?] OFF | ON
INITiate:CONTinuous ON activates the continuous measurement mode. In this mode, a new
measurement is automatically started when a measurement is terminated. The power sensor module
first enters the WAIT_FOR_TRIGGER state and begins with the measurement as soon as the trigger
condition is fulfilled. Once the measurement is completed, the sensor again enters the
WAIT_FOR_TRIGGER state. The power sensor module will measure continuously assuming
continuous trigger events.
In contrast, each measurement cycle must be explicitly started with the INITiate:IMMediate command
after the INITiate:CONTinuous OFF command has been sent. After triggering and completion of the
measurement, the power sensor module enters the IDLE status and remains in this status until a new
measurement is started with the INITiate:IMMediate command.
1169.3870.12
Parameter
OFF | ON
9
1 to 2×10
x to 100.0
OFF | ON
0.0 to 10.0
0.0 to 3.0
x to y
POSitive | NEGative
BUS | EXTernal | HOLD | IMMediate | INTernal
Remote Control - Commands
Unit
s
s
dB
W
6.17
Remarks
No query
No query
No query
E-2