Test; Test:sensor - R&S NRP-Z27 Operating Manual

Remote Control - Commands

TEST

Table 6-7 Commands of the TEST system
Command

TEST:SENSor?

TEST:SENSor?
TEST:SENSor? triggers a selftest of the power sensor module. In contrast to *TST, this command
yields detailed information, which is useful for troubleshooting.
No signal may be applied to the power sensor module while the selftest is running.
If the selftest is carried out with a signal being present, error messages may erroneously
be output for the test steps "Offset Voltages" and/or "Noise Voltages".
1169.3870.12
Parameter Unit
6.16
R&S NRP-Z27/-Z37
Remarks
Query only
E-2