R&S NRP-Z27 Operating Manual page 11

R&S NRP-Z27/-Z37
Operation with the Measuring Receiver R&S FSMR
Connecting the power sensor module to the R&S FSMR
The power sensor module can be connected to the Measuring Receiver R&S FSMR when it is in
operation. The multiple circular plug-in connector must be inserted, red marking upwards, into the
POWER SENSOR connector. Then connect the 3.5 mm male connector of the RF cable with
measurement input RF INPUT 50
first install the appropriate test port adapter with 3.5 mm female connector (R&S 1021.0512.00). With
model R&S FSMR3, which has a built-in N-connector, screw on the adapter with the 3.5 mm female
connector and male N connector that is supplied. Only the use of these adapters ensures correct
functioning of the VSWR Correction function on the R&S FSMR.
1169.3870.12
Make sure the bending radius of the RF connecting
cable is at least 75 mm!
> 150 mm
A tighter bend can permanently impair the
measuring accuracy of the power measurement
module!

. If you are using model R&S FSMR26 or R&S FSMR50, you must
1.3
Connecting the sensor
! !
E-6