Table of Contents
Advertisement
Tone Parameter Settings
The table below shows the parameters that can be configured on the tone editor screen. For information about each parameter,
also refer to "Tone Creation Overview" (page E-44).
The settings marked with an asterisk (*) in the "Setting Range" column are initial defaults.
Parameter Name
AttackTime
(Attack Time)
ReleasTime
(Release Time)
CutOff
(Cutoff Frequency)
Vib.Type
(Vibrato Type)
Vib.Depth
(Vibrato Depth)
Vib.Rate
(Vibrato Rate)
Vib.Delay
(Vibrato Delay)
Oct.Shift
(Octave Shift)
Volume
(Volume)
TouchSense
(Touch Sense)
Rev.Send
(Reverb Send)
Cho.Send
(Chorus Send)
DSP On Off
(DSP On/Off)
DSP
DSP Type
(DSP Type)
Specifies the time until a note starts to sound after a key is pressed.
Specifies the time a note continues to sound after a key is released.
Adjusts timbre by attenuating note components that are higher than a certain
frequency. A larger value produces a brighter, harder sound, while a lower
value produces a mellower, softer sound.
Specifies the vibrato type (vibrato waveform).
Setting
Sin
Sine wave
Tri
Triangle wave
Saw
Sawtooth wave
Sqr
Square wave
Specifies how much vibrato is applied to a note.
Specifies the speed of the vibrato applied to a note.
Specifies how much time elapses until vibrato starts.
Shifts the pitch upwards or downwards in octave steps.
Specifies the volume level of all tones. A larger value sets a higher volume
level.
Specifies how much the volume changes in accordance with the relative
amount of pressure applied to keyboard keys. A larger positive value results
more change in volume in accordance with key pressure. A larger negative
values results in less change in volume in accordance with key pressure. Key
pressure does not affect volume when a value of 0 is set.
Specifies how much reverb is applied for each tone.
Specifies how much chorus is applied for each tone.
Specifies whether DSP should be applied (on) or not applied (oFF) to notes.
The following four settings become enabled when "on" is selected for this
setting.
Specifies the DSP to be applied to tones using DSP numbers (001 to 100:
Preset DSPs; 101 to 200: User DSPs). Selecting "ton" applies the initial preset
DSP of each tone.
Shows the DSP type number corresponding to the above DSP value that is set
automatically as the initial default setting.
setting and select a different DSP type.
Description
Description
Waveform
*1
You can modify the initial default
Using the Tone Editor
Setting Range
*
–64 to 0
to +63
*
–64 to 0
to +63
*
–64 to 0
to +63
*
Sin
, Tri, Saw, Sqr
*
–64 to 0
to +63
*
–64 to 0
to +63
*
–64 to 0
to +63
*
–2 to 0
to +2
*
0 to 127
–64 to 0 to +63
*
0 to 40
to 127
*
0
to 127
*
oFF
, on
*
ton
, 001 to 200
*1
01 to 46
E-47
*
Advertisement
Table of Contents
