Table of Contents
Advertisement
Using the Mixer
MIC/INST Parameters
MIC/INST parameters include settings related to the T-5 (INST IN) and T-8 (MIC IN) terminals.
Parameter Name
Part
(Mic/Inst Enable)
Volume
*1
(Mic/Inst Volume)
Pan
(Mic/Inst Pan)
DSP Line
(Mic/Inst DSP Line)
Rev.Send
(Mic/Inst Reverb Send)
Cho.Send
(Mic/Inst Chorus Send)
N.Thresh
(Mic/Inst Noise Gate
*1
Threshold)
N.Release
(Mic/Inst Noise Gate
*1
Release)
Auto Level
(Mic/Inst Auto Level
*1
Control)
*1 See the block diagram under "Configuration of Effects" (page E-31).
E-42
Specifies if sound input should be output (on) or not output (oFF).
Specifies the volume level of sound input.
Specifies the stereo pan position of sound input. 0 indicates the center, while a
smaller values shifts to the left and a larger value shifts to the right.
Specifies whether DSP should be applied to sound input.
Specifies how much reverb is applied to sound input.
Specifies how much chorus effect is applied to sound input.
Cuts low-volume input sounds, which decreases noise. Allows a signal to pass
through if it is above the set threshold (gate open). Does not allow a signal to
pass if it is below the threshold (gate closed).
Specifies the amount of time for the gate to go from open to fully closed when an
input sound signal falls below the threshold value specified by "N.Thresh".
Setting 0 will abruptly cut off the sound, while a larger value will cause the gate
to close more slowly.
Automatically controls the input signal level. Selecting "oFF" disables this
feature, while a larger value applies a greater degree of control.
Description
Setting Range
*
oFF, on
*
0 to 80
to 127
*
–64 to 0
to +63
*
oFF
, on
*
0 to 40
to 127
*
0
to 127
*
0 to 20
to 127
*
0 to 64
to 127
*
oFF
, 1 to 3
B
Advertisement
Table of Contents
