Table of Contents
Advertisement
Using the Song Sequencer
5.
Use buttons R-1 (5) to R-4 (•) and buttons R-7 (6) to R-10 (,) to specify the length of the note you want
to input.
• For information about how to specify note lengths, see step 4 under "To insert an event" (page E-89).
• You can perform the following operations during step input to insert ties and rests.
To do this:
Tie the note at the
current cursor position
with the note event
immediately before it
Insert a rest before the
current cursor position
6.
Press the keyboard key that corresponds to the note you want to input.
• The note is input as soon as you press the keyboard key, and the cursor will move by the length you specified in step 5 to the
next measure:beat:tick. From there you can input the next note, if you want.
7.
Repeat steps 5 and 6 to input the notes you want.
• If you want to input a series of notes of the same length, skip step 5 and perform step 6 only.
8.
After inputting all of the notes you want, press the R-15 (EXIT) or R-17 (t, y) buttons.
• This returns to the event editor screen.
Input Menu Setting Items
Pressing the C-17 (MENU) button while holding down the R-13 (FUNCTION) button during step input will display the input menu.
The following explains the meanings and setting ranges of the input menu items. The settings marked with an asterisk (*) in the
"Setting Range" column are initial defaults.
Item name
GateRate
Specifies the gate rate as a percentage of the actually input gate length for the
(Gate Rate)
length (gate length) of the note event that was specified using buttons R-1 (5)
through R-4 (•) and R-7 (6) through R-10 (,). Specifying a GateRate of
080% and inputting a quarter note (96 ticks), for example, will result in a GATE
setting of 00:76 (96
Velocity
Specifies the velocity value of an input note event or chord event. Specifying
(Velocity)
"KeyOn" inputs a velocity value in accordance with applied key pressure.
SysTrack
Selects either note event input or chord event input when inputting to the
(System Track)
system track.
E-96
1. At the current cursor position, specify the length of the note you want to tie with the immediately
preceding note event.
2. Press the R-11 (.) button.
• This adds the length of the note you specified in step 1 to the length of the note immediately
preceding it. At this time, the cursor will move forward by the timing of the added amount.
6
2
6
A B
A
1. At the current cursor position, specify a note that is the same length as the rest you want to insert.
2. Press the R-5 (REST) button.
• The cursor will move forward by the length of the note you specified in step 1.
6
2
6
B
0.8 = 76.8, cut off to 76).
X
Perform this operation:
2 2
A
Preceding note event
B
Current cursor position
C
C
Cursor position after process
2
B
Current cursor position
C
C
Cursor position after process
Description
Setting Range
*
001% to 080%
to 100%
*
KeyOn, 001 to 100
to 127
*
note
, Chord
Advertisement
Table of Contents
